beautypg.com

Comtech EF Data CDM-760 User Manual

Page 152

background image

Front Panel Operation

Revision 2

CDM-760 Advanced High-Speed Trunking Modem

MN-CDM760

6–66

6.2.6.8.2 (Utility: Firmware Images) Select

Current Active Image is #1

Next Reboot, will use Image: #1

The read-only top line shows the active firmware image. This example shows Image #1 as the

Current Active Image.

On the bottom line – Use the  arrow keys to select the standby image (in this example, Image

#2) if desired. Press ENTER. You are then prompted to reboot the unit.

6.2.7 SELECT: ODU (Outdoor Unit)

The BUC:PwrSupply+Ref and FSK-control selections are reserved for future use and

are non-operational at this time.

ODU: BUC:PwrSupply+Ref

LNB:PwrSupply+Ref FSK-control ()

Use the   arrow keys to select LNB: PwrSupply+Ref. Press ENTER.

6.2.7.1 (ODU:) LNB:PwrSupply+Ref

LNB control/monitor:

PSU-and-10MHz PSUmonitor ()

Use the   arrow keys to select a parameter. Press ENTER.

(ODU: LNB:PwrSupply+Ref) PSU-and-10MHz

LNB: Voltage=Off 10MHz=Off (Off,On)

Alarm limits, from 000 to 500 mA

()

Use the   arrow keys to select a parameter. Press ENTER.

(ODU: LNB:PwrSupply+Ref) PSU-and-10MHz Voltage

Use the  arrow keys to select Off, 13V DC, 18V DC, or 25V DC. Press ENTER.

Any setting other than Off configures the rear panel J9 | L-BAND RX IN Type ‘N’

connector.

(ODU: LNB:PwrSupply+Ref) PSU-and-10MHz 10MHz

Use the  arrow keys to select Off or On. Press ENTER.