Comtech EF Data CDM-760 - Manual (Page 258)

Serial-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
8–24
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
GE2 Link
Configuration
LC2 = 1 byte, value
of 0 thru 6
Command or Query.
Sets or returns the GE2 Interface mode in the form x, where:
0 = Auto Negotiate (default)
1 = 1000Mbps Full Duplex
2 = 100Mbps Full Duplex
3 = 100Mbps Half Duplex
4 = 10Mbps Full Duplex
5 = 10Mbps Half Duplex
6 = Off
LC2=
LC2?
LC2*
LC2#
LC2? LC2=x
(see Description of
Arguments)
Negotiated
Port Status
N/A 2 bytes Query only
Returns GE1/GE2 port status in the form ab, where:
a = GE1 status
b = GE2 status defines as follows:
0 = Not Resolved or No Link
1 = 10 Mbps Half-Duplex
2 = 10 Mbps Full-Duplex
3 = 100 Mbps Half-Duplex
4 = 100 Mbps Full-Duplex
5 = 1000 Mbps Full-Duplex
EXAMPLE: <0/NPS?
<0000/NPS=55 (1000 Mbps both ports)
N/A NPS? NPS=ab
(see Description of
Arguments)
Gig Optical
Ethernet
Interface
LC3 = 1 byte, value
of 0 or 1
Command or Query.
Sets or returns the GigE Optical Ethernet Interface mode in the form x, where:
0 = Off
1 = On
NOTE: Option must be purchased and SFP module installed!
LC3=
LC3?
LC3*
LC3#
LC3? LC3=x
(see descriptor
arguments)
Inband
Communi-
cations
SLC = 1 byte, value
of 0 or 1
Command or Query.
Sets or returns isolation (opening) or connection of the SERDES link between the management Ethernet
port and the data Ethernet ports, in the form x, where:
0 = InBand Disabled
1 = InBand Enabled
SLC=
SLC?
SLC*
SLC#
SLC? SLC=x
(see Description of
Arguments)
GBEI Flow
Control
GFC = 1 byte, value
of 0 or 1
Command or Query.
Enables or disables flow control in the form x, where:
0 = Disable GBEI Flow Control
1 = Enable GBEI Flow Control
NOTE: Applies to all ports.
GFC=
GFC*
GFC#
GFC? GFC=x (see
Description of
Arguments)
GBEI MAC
Learning
LRN = 1 byte, value
of 0 or 1
Command or Query.
Enables or disables MAC address learning in the form x, where:
0 = Disable MAC learning
1 = Enable MAC learning
NOTE: Applies to all ports.
LRN=
LRN?
LRN? LRN=x (see
Description of
Arguments)
SNMP Read
Community
SRC = 1 to 20 bytes,
characters,
no spaces
Command or Query.
Sets or returns SNMP read community string.
NOTE: Empty string is not allowed
EXAMPLE: <0/SRC=public
SRC=
SRC!
SRC? SRC=x
(see description of
arguments)