beautypg.com

Comtech EF Data CDM-760 User Manual

Page 375

background image

Appendix H

Revision 2

CDM-760 Advanced High-Speed Trunking Modem

MN-CDM760

H–9

To open the Carrier ID page (

Figure H-3), click the Configuration navigation tab, and then

select the CID page tab.

Figure H-3. Configuration | CID Page

Meta-Carrier Info

The read-only

MAC Address for t

he M&C card on the CDM-760 is displayed here.

• Set the modem’s physical location in Latitude in the form DDMM.mmC, where:


o

DD = degrees (00 through 90)

o

MM = whole minutes (00 through 60)

o

mm = fractional minutes (0 through 99 (tenths or hundredths))

o

C = compass cardinal point (N = North, S = South)

• Set the modem’s physical location in Longitude in the form DDDMM.mmC, where:


o

DDD = degrees (000 through 180)

o

MM = whole minutes (00 through 60)

o

mm = fractional minutes (0 through 99 (tenths or hundredths))

o

C = compass cardinal point (E = East, W = West)

• Enter a CID Telephone Number to provide a valid emergency contact number to call to

resolve operational issues – e.g., in case the modulator’s Tx output is causing interference

on the satellite. Providing this phone number allows a satellite operator to quickly call the

person(s) responsible for correcting any issues.

• Create a Custom Message to provide additional information that may be useful in resolving

operational issues, e.g., to quickly resolve interference.

• Use the Carrier ID State drop-down list to select operation as On or Off. This setting enables

the transmission of CID information by the modem. The default is On.

Click [Submit] to save your settings.