Connector, Group, 1 if connector group – Comtech EF Data CDM-760 User Manual
Page 53: 1 rx connectors, 2 tx connectors, 3 j10 | tx mon connector, type ‘sma

Rear Panel Connections
Revision 2
CDM-760 Advanced High-Speed Trunking Modem
MN-CDM760
3–5
3.2.1 IF Connector Group
CAUTION – THERE MAY BE DC VOLTAGES PRESENT ON THE TYPE ‘N’ RX AND TX IF
CONNECTORS, UP TO A MAXIMUM OF 48 VOLTS.
3.2.1.1 Rx Connectors
The J9 | L-BAND RX IN Type ‘N’ connector features an LED labeled “LNB PWR
ON”. When a Low-Noise Block Down Converter (LNB) is installed in an L-Band
configuration, the LED lights amber to indicate the presence of DC voltage.
Ref Des Name
Connector Type
Description
Direction (I/O)
J9
L-BAND RX IN
Type ‘N’ female
Rx IF signal, L-Band
I
J11
IF RX IN
BNC
Rx IF signal, 70/140 MHz band
Note: 75Ω default, 50Ω optional
3.2.1.2 Tx Connectors
The J12 | L-BAND TX OUT Type ‘N’ connector features an LED labeled “BUC
PWR ON”. When a Block Up Converter (BUC) is installed in an L-Band
configuration, the LED lights amber to indicate the presence of DC voltage.
Ref Des Name
Connector Type
Description
Direction (I/O)
J12
L-BAND TX OUT Type ‘N’ female
Tx IF signal, L- band
O
J13
IF TX OUT
BNC
Tx IF signal, 70/140 MHz band
Note: 75Ω default, 50Ω optional
3.2.1.3 J10 | TX MON Connector, Type ‘SMA’
The Type ‘SMA’ female J10 | TX MON connector provides a user monitor
output for the L-Band signal.
Ref Des Name
Connector Type
Description
Direction (I/O)
J10
TX MON
Type ‘SMA’ female
Monitor L-Band Tx IF Output
O