Comtech EF Data CDM-760 - Manual (Page 178)

Ethernet-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–20
Configure your settings as needed. Click [Submit] to save.
See Chapter 6. FRONT PANEL OPERATION for information about the configuration
parameters available on this page:
Operational Feature / Section Chapter 6 Section Reference
Network Spec
6.2.2.1.1 (CONFIG: NetSpec) Network Spec
Operating Mode 6.2.2.1.2 (CONFIG: NetSpec) Operating Mode
Transmit 6.2.2.2 CONFIG: Tx
Receive 6.2.2.3 CONFIG: Rx
Carrier-in-Carrier (CnC)
• 6.2.2.5 CONFIG: CnC
• Also see: Appendix J. D OUBLE T ALK C ARRIER - IN -C ARRIER OPTION
ACM
• 6.2.2.2.5 (CONFIG: Tx) ACM
• Also see: Appendix G. ADAPTIVE CODING AND MODULATION
OPTION
AUPC
• 6.2.2.2.4 (CONFIG: Tx) Power PowerControl AUPC and
(CONFIG: Tx) Power  AUPC
7.4.4.3.2 Configuration | Interface Pages
Be sure to read about Single Stream Mode vs. MultiStream Mode Operation in
Chapter 6. FRONT PANEL OPERATION before you attempt to use either of the
Interfaces pages.
Use the Interface pages to configure and monitor the available base unit and optional Ethernet
and optional PIIC traffic data interfaces at the CDM-760 rear panel:
• The J5 | DATA Ethernet port;
• The J6 | DATA Ethernet port;
• The J7 | OPTICAL port, used with the optional Optical Ethernet SFP (Small Form Factor
Pluggable) module;
• PIIC Slot 1 (PIIC1) and Slot 2 (PIIC2), which accept the optional G.703 E3/T3/STS-1, OC-3
Single / Multi Mode, and STM-1 Copper PIIC modules.
• High-Speed Packet Processor – When installed, operation of the rear panel J4 |MGMT, J5 |
DATA, and J6 | DATA Ethernet ports are disabled and operation is transferred by the
modem to the Packet Processor’s P0 | MGMT, P1 | DATA, P2 | DATA, P3 | DATA, and P4 |
DATA Ethernet ports.
Use of the PIIC slots is unavailable when the Packet Processor is installed.
Click the Interface primary page tab, and then select the Ethernet or PIIC tab to continue.