Port write tx enable, Port write rx enable, I/o and doorbell settings – Altera RapidIO MegaCore Function User Manual
Page 42: I/o logical layer interfaces, I/o slave address width, I/o read and write order preservation, Port write tx enable –6 port write rx enable –6, I/o and doorbell settings –6

3–6
Chapter 3: Parameter Settings
I/O and Doorbell Settings
RapidIO MegaCore Function
August 2014
Altera Corporation
User Guide
Port Write Tx Enable
Port write Tx
enable turns on or turns off the transmission of port-write requests by
the Maintenance Logical layer module.
Port Write Rx Enable
Port write Rx enable
turns on or turns off the reception of port-write requests by the
Maintenance Logical layer module.
I/O and Doorbell Settings
This page lets you enable and configure the Input/Output and Doorbell Logical layer
modules
I/O Logical Layer Interfaces
I/O logical layer Interfaces
selects whether or not to add an Avalon-MM master
interface and whether or not to add an Avalon-MM slave interface. You can specify
one of the following options:
■
Avalon-MM Master and Slave
■
Avalon-MM Master
(this option is not valid in Arria 10 variations)
■
Avalon-MM Slave
(this option is not valid in Arria 10 variations)
■
None
For RapidIO IP core variations that target an Arria 10 device, only two of the values
are valid. Arria 10 variations either include both an I/O Logical layer master module
and an I/O Logical layer slave module (Avalon-MM Master and Slave) or do not
include a I/O Logical layer module (None).
I/O Slave Address Width
I/O slave address width
specifies the Input/Output slave address width. The default
width is 30 bits.
However, because the I/O Logical layer slave module addresses all hold word
address values in 1x variations or double-word address values in 2x and 4x variations,
the width of the external I/O Logical layer slave module address busses is the value
you specify, minus 2 in 1x variations, or the value you specify, minus 3 in 2x and 4x
variations.
I/O Read and Write Order Preservation
I/O read and write order preservation
controls support for order preservation
between read and write operations (NWRITE, NWRITE_R, SWRITE, and NREAD requests) in
the I/O Avalon-MM Logical layer slave module. By default this feature is turned off.
This parameter is available only if you set I/O logical layer Interfaces to Avalon-MM
Master and Slave
or Avalon-MM Slave.