Altera RapidIO MegaCore Function - Manual (Page 144)

6–12 Chapter 6: Software Interface
Transport and Logical Layer Registers
RapidIO MegaCore Function August 2014 Altera Corporation
User Guide
Table 6–13. Device Information CAR—Offset: 0x04
Field Bits Access Function Default
DEVICE_REV [31:0] RO Hard-wired device revision level (1)
Note to Table 6–13 :
(1) The default value is set in the RapidIO parameter editor.
Table 6–14. Assembly Identity CAR—Offset: 0x08
Field Bits Access Function Default
ASSY_ID [31:16] RO Hard-wired assembly identifier (1)
ASSY_VENDOR_ID [15:0] RO Hard-wired assembly vendor identifier (1)
Note to Table 6–14 :
(1) The default value is set in the RapidIO parameter editor.
Table 6–15. Assembly Information CAR—Offset: 0x0C
Field Bits Access Function Default
ASSY_REV [31:16] RO Hard-wired assembly revision level (1)
EXT_FEATURE_PTR [15:0] RO
Hard-wired pointer to the first entry in the extended feature list.
This pointer must be in the range of 16'h100 and 16'hFFFC.
(1)
Note to Table 6–15 :
(1) The default value is set in the RapidIO parameter editor.
Table 6–16. Processing Element Features CAR—Offset: 0x10 (Part 1 of 2)
Field Bits Access Function Default
BRIDGE [31] RO Processing element can bridge to another interface. (1)
MEMORY [30] RO
Processing element has physically addressable local address
space and can be accessed as an endpoint through
nonmaintenance operations. This local address space may be
limited to local configuration registers, on-chip SRAM, or other
device.
(1)
PROCESSOR [29] RO
Processing element physically contains a local processor or
similar device that executes code. A device that bridges to an
interface that connects to a processor does not count.
(1)
SWITCH [28] RO
Processing element can bridge to another external RapidIO
interface—an internal port to a local endpoint does not count as
a switch port.
(1)
RSRV [27:7] RO Reserved 21'h0
RE_TRAN_SUP [6] RO
Processing element supports suppression of error recovery on
packet CRC errors:
1'b0—The error recovery suppression option is not
supported
1'b1—The error recovery suppression option is supported
1'b0