Obtaining and installing a license key – Dell PowerVault ML6000 User Manual
Page 88
Chapter 5 Configuring Your Library
Obtaining and Installing a License Key
Dell PowerVault ML6000 User’s Guide
88
different tape drive. You can also disable a partition’s control path by
clearing the current control path selection.
The paths to open the appropriate screens are as follows:
• From the Web client, select
Setup > Control Path
.
• From the operator panel, select
Setup > Control Path
.
Obtaining and Installing a License Key
Several features can be added to the standard library configuration either
with your initial purchase or afterward (see
Caution:
Do not select an FC tape drive as control path if it is
connected to an FC I/O blade. The control path will be
filtered out by the I/O blade and will not be visible to the
host.
Note:
You may need to modify settings in your host application as a
result of modifying the control path. See your host application
documentation.
Note:
Bold column headings in the table can be sorted. For example,
selecting the
Location
column heading will sort by location
coordinates.
Note:
If you have more than one FC I/O blade in the library, each FC
I/O blade will present each partition — that does not have a
tape drive as the control path — as a target device to the host.
Thus the host may see the same partition multiple times. To
minimize confusion, you should configure host mapping so
that each host sees each device only once. See