Dell POWERVAULT MD3600I User Manual
Important information
![background image](/manuals/618786/1/background.png)
Carrier Grade Updates for Dell
PowerVault MD3600/MD3620
x
and
MD1200/MD1220 Storage Arrays
Important Information
NOTE:
This information is relevant to Dell PowerVault MD3600i, MD3620i, MD3600f,
MD3620f, MD1200, and MD1220 series storage arrays.
WARNING:
The intra-building port(s) of the equipment or subassembly is suitable for
connection to intra-building or unexposed wiring or cabling only. The intra-building
port(s) of the equipment or subassembly must not be metallically connected to
interfaces that connect to the Outside Plant (OSP) or its wiring. These interfaces are
designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described
in GR-1089-CORE, Issue 5) and require isolation from the exposed OSP cabling. The
addition of Primary Protectors do not provide sufficient protection to connect these
interfaces metallically to the OSP wiring.
WARNING:
The intra-building port(s) of the equipment or subassembly must have
shielded intra-building cabling or wiring that is grounded at both ends.
• Network equipment — Includes standard PCIe based Network Interface Card
(NIC) and Fibre Channel (FC) devices.
• Bonding network — Equipment is suitable for Common Bonding Networks
(CBNs).
• Suitable installation location — Equipment is suitable for installation in
Network Telecommunications Facilities (NTF), and locations where the
National Electrical Code (NEC) is applicable.
• DC bonding — Equipment is suitable for DC common bonding installations.
• Fan filter — The filter material in the filter bezel is 0.25 inch thick, 45PPI
foam, and has an ASHRAE dust by weight arrestance of 80%. The filter must
be replaced on a quarterly basis.
NOTE:
You can order a service kit containing four replacement filters by contacting
Dell Support.
2013 - 02
Rev A00