Dell PowerVault ML6000 - Manual (Page 193)

Chapter 10 Getting Information – Logs and Reports
Viewing Logged-in Users
Dell PowerVault ML6000 User’s Guide 193
•
IPv6 Settings
(if IPv6 is enabled) — DHCP enabled/disabled,
Stateless enabled/disabled, Static enabled/disabled, network prefix,
gateway, and all IPv6 addresses.
•
SSL
— SSL, port, and cipher of the library.
•
SMI-S
— access and state enabled/disabled settings of the library.
•
Access
: Indicates whether the SMI-S port for SMI-S traffic to the
library (port 5988) is enabled or disabled. You can change the
setting via the operator panel,
Tools > Security
menu. The default
setting is enabled.
•
State
: Indicates whether allowing SMI-S to run on the library is
enabled or disabled. You can change this setting on the operator
panel,
Tools > System Settings
. The default is disabled.
•
SNMP
— access enabled/disabled, V1 enabled/disabled, V2
enabled/disabled, V3 enabled/disabled, algorithm, encryption
enabled/disabled, and port.
•
SNMP-Traps
— IP addresses and ports.
The path to open the report from the Web client is
Reports > Network
Settings
.
Viewing Logged-in Users
The Logged-in User’s Report report contains information about the users
that are currently logged into the library. The report contains the
following information:
•
User name
— Name of logged-in user.
•
Role name
— Privilege level of logged-in user (for example,
Admin
for
administrator,
User
for non-administrator, non-service user).
•
Login date and time
— Date and time the user logged into the library.
•
Last activity date and time
— Date and time the user last logged into
the library.
•
Login location
— IP address or host name of the system being used to
access the system.