Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 97)

5–13 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
Pass-Through Application File Transfers
Pass-Through file transfers, which are initiated by PanelBuilder and
are available only when the terminal is in Run mode, can be
performed over the following networks:
•
DH+ and Remote I/O networks, using the PLC-5 or SLC-5/04
controller’s Pass-Through feature
•
ControlNet and Remote I/O networks, using the PLC-5C
controller’s Pass-Through feature
•
Ethernet and Remote I/O networks, using the PLC-5E controller’s
Pass-Through feature
The file transfer can proceed using the Pass-Through parameters of
the terminal’s current application. If there is no current application or
Pass-Through parameters, or you don’t want to use the application’s
parameters, you can change the Pass-Through parameters in File
Transfer Utility and PanelView. The File Transfer Utility and
PanelView Pass-Through parameters must match.
For Pass-Through uploads, if you want to change the current
application’s transfer parameters, see Terminal Network Setup for
Remote I/O Applications in this chapter.
For Pass-Through downloads, if you want to change the current
application’s transfer parameters or you do not have a current
application selected, choose the Transfer Setup button, and then
select the Network tab in the Transfer Setup screen.
For Remote I/O Pass-Through applications, you can change the baud
rate and the control byte.