Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 27)

1–14 Introducing the PanelView Terminals
Publication 2711E-6.17 – November 1998
PanelView terminals can be connected to any Allen-Bradley 1771
Remote I/O, Data Highway Plus, or ControlNet link. Applicable host
controllers include almost all Allen-Bradley Programmable Logic
Controllers, as well as certain IBM computers, interface cards, VME
Controllers, and the DEC

Q-Bus

interface.
Newly-released Allen-Bradley programmable controllers not yet
listed will support PanelView terminals as long as the terminals
support 1771 Remote I/O, DH+, or ControlNet networks.
Remote I/O Communications
The terminal can occupy
from ¼ up to 64 I/O racks in a PLC. It has
the same configurability as—and more than—a standard I/O rack.
Refer to your applicable Allen-Bradley Programmable Controller
and Remote I/O Scanner user’s manuals for connection and Remote
I/O configuration limitations.
The following host controllers can be connected to the terminals over
a Remote I/O link.
Logix55xx
You can connect one or more terminals to a 1756-DHRIO
DH+/Remote I/O Module with other I/O racks.
PLC-5/11, 5/15, 5/20, 5/25, 5/30, 5/40, 5/60, 5/80, and 5/250
Processors
You can connect one or more terminals directly to a PLC-5 Remote
I/O Port (in Scanner Mode) with other I/O racks. If the PLC-5
Remote I/O Port is used in the adapter mode, one or more terminals
can be connected to that PLC-5 along with other I/O racks via a
1771-SN I/O Subscanner Module.
The terminals can communicate at 57.6, 115.2, and 230.4 kilobauds
with any PLC-5 that can support those baud rates.
If you are using a PLC-5/15 with partial rack addressing and block
transfers, you must use PLC-5/15 Series B, revision J or later.
PLC-5/10 Processor
One or more terminals can be connected to this processor with other
I/O racks by a 1771-SN I/O Subscanner Module.
Applicable Programmable
Controllers and
Connections