Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 82)

4–15 Installing PanelView 1400e Terminals
Publication 2711E-6.17 – November 1998
To connect the PanelView 1400e terminal to the ControlNet network:
" Connect a PanelView Terminal to a ControlNet network via a tap
with a 1-meter (39.4-in.) drop cable. Use any tap with one of the
following catalog numbers: 1786-TPS, 1786-TPYS, 1786-TPR,
or 1786-TPYR. See the ControlNet PLC-5 Programmable
Controllers User Manual (A-B Publication 1785-6.5.14) for more
information about ControlNet taps.
Note: ControlNet taps contain passive electronics and must be
purchased from Allen-Bradley for the network to function properly.
Note: If the terminal is the last device on the link, connect a 75-ohm,
1-watt terminating resistor to the unused connector on the tap (A-B
Catalog Number 1786-XT).
See the ControlNet PLC-5 Programmable Controllers User Manual
(A-B Publication 1785-6.5.14), the ControlNet Communication
Interface Card (A-B Publication 1784-5.20), and the ControlNet
Planning and Installation Manual (A-B Publication 1786-6.2.1) for
more information about ControlNet.
Using a Keyboard or Bar Code Reader
The terminal supports a keyboard or a bar code reader, which you
can connect to the terminal’s keyboard port. See Figures 4.13 and
4.14 for the location of the keyboard port on the bottom of the
terminal. The keyboard port is covered with a protective, black label.
Remove the perforated area of the label to expose the keyboard port.
The supported keyboards (A-B Part Numbers 6189-KBM1,
6189-KBD1, and 6189-KBE1) or supported bar code reader (A-B
Part Number 2755HDG4 Series A, Revision C) can be used with:
•
ASCII Input Objects (for touch screen and keypad terminals)
•
Numeric Entry Keypad Object (for touch screen terminals only)
•
Numeric Keypad Enable Button (for keypad terminals only)
•
Numeric Input Cursor Point (for keypad terminals only)
•
Set Bit Cursor Point (for keypad terminals only)
For more information on touch screen or keypad input objects, see
the PanelBuilder 1400e Configuration Software for Windows
Reference Manual.
Figure 4.13 shows the keyboard connection to the PanelView 1400e
terminal. Figure 4.14 shows the bar code reader connection to the
PanelView 1000e terminal, with the option of connecting the
keyboard.
"
"