Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 190)

Appendix
D
Publication 2711E-6.17 – November 1998
Installing the PanelView Serial
Firmware Upgrade Utility
The Serial Firmware Upgrade Utility Version 5 (SFU32) is provided
on CD-ROM. The software installation program creates a directory
on your hard drive for the SFU32 and copies all necessary files to it.
By default, the drive and directory is C:\AB\PB1400E\SFU32. You
can change this default.
To install SFU32:
1. Start Windows NT or Windows 95. If you’re already in Windows,
close all open Windows applications.
2. Place the CD-ROM in the drive.
The CD-ROM should begin to run automatically. If it does not
start automatically, choose Run from the Start button and select
setup.exe from the CD-ROM drive; or select setup.exe from
Windows Explorer.
3. In the Welcome dialog box, choose Next.
4. If you are installing on Windows 95, the Select Version dialog
box appears. Select Version 5, and then choose Next.
If you are installing on Windows NT, the Select Version dialog
box does not appear. Version 5 is automatically selected.
5. In the Choose Applications dialog box, choose Serial Firmware
Upgrade as the application you want to install. You can choose
more than one application to install. Choose Next.
6. In the registration dialog box, enter your user name, company
name, and serial number. You can obtain registration information
from the software registration card that is in your
PanelBuilder 1400e package (A-B Catalog Number 2711E-ND1).
Choose Next.
7. In the confirmation dialog box, verify the user information you
have entered. Select Yes to proceed or No to edit the user
information.
8. In the Welcome dialog box for the Serial Firmware Upgrade
Utility, it recommends that you close all open Windows
applications. If you have done that, choose Next.
9. Choose the drive and directory in which the SFU32 will be
installed. By default, this is C:\AB\PB1400E\SFU32. To change
the destination drive or directory, type the new drive and/or
directory in the Program Files box. Choose Next.
Installing SFU32 from
CD-ROM on Windows NT
or Windows 95