Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 112)

5–28 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
The list displays the operators and any assigned security codes.
3. Scroll through the list of operators using the Up and Down
arrows. Highlight the operator you want to assign a security code
to.
4. To set an operator’s code, enter a numeric sequence up to five
characters long. On a touch screen terminal, use the keypad on
the screen. On a keypad terminal, use the numeric keypad. On an
external keyboard, use the Backspace key to represent
←
, the
Enter key to represent
↵
, and the numeric keys to represent 0 to 9.
Choose Enter to set the code.
5. Assign all the required operator codes.
6. Choose OK when you are finished to save this information.
Screen Security
Screen security, even if configured in PanelBuilder, is not in effect
until the Screen Security setting is enabled at the terminal. Once
enabled, operators can access a restricted screen only by entering the
correct security code. If the code is invalid, the requested screen
won’t be displayed.
In the Security screen, select the Global tab to display the following
screen.