Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 123)

5–39 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
To set the Stuck Cell timeout:
" Use the Up and Down arrows to set the amount of time from 0 to
60 seconds. A setting of 0 disables the function. The default
setting is 0.
Screen Saver Display Intensity (1000e only)
Use the Screen Saver tab to set the intensity level for the screen
saver display, and to dim or switch off the backlight. Frequent
switching off can shorten the life of the backlight. (For information
on backlight replacement, see Chapter 7, Maintaining PanelView
Terminals.) When the backlight is dimmed, you can still see the
screen saver graphic.
To set the intensity level for the screen saver:
1. In the Terminal Response screen, choose the Screen Saver tab to
display the following screen.
2. Use the Backlight Intensity Level button to cycle through the
intensity levels. You can also use the button to switch off the
backlight. The default is set at the lowest intensity level, which is
50%. To test the intensity level you have set, use the Test Screen
Saver button.
3. Set the Screen Saver Timeout. The default setting is 0, which
disables the screen saver. For details on the screen saver timeout
feature, see Screen Saver Timeout below.