Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 113)

5–29 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
You can enable or disable screen security for the application you are
running.
•
Enable
ĊIf you enable screen security, only authorized operators
will have access to screens with screen security assigned.
•
Disable
ĊIf you disable screen security, all operators will have
access to all screens, whether or not the screens have security
assigned to them. The Disable setting is the default.
Mode Switch
In the Security screen, select the Mode Switch tab to display the
following screen.
For the Software Mode Switch to operate, the terminal’s hardware
keyswitch must be in Run mode. Use the Software Mode Switch
button to enable or disable the Goto Configure Mode button, which
is displayed in an application running on the PanelView terminal.
Operators can use the Goto Configure Mode button to switch
between Run and Configure modes without using the hardware
keyswitch.
Important: If the Software Mode Switch is set to Enable, the Goto
Configure Mode button is displayed without access
restrictions on both the Transfer Application screen and
the Major Fault window, as shown below. This may
pose a security issue, because all operators will be able
to switch between Run and Configure modes.