Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 30)

1–17 Introducing the PanelView Terminals
Publication 2711E-6.17 – November 1998
ControlNet Communications
To communicate on ControlNet, install a ControlNet Communication
Interface Card (A-B Catalog Number 1784-KTCx, Series B or later,
or 1784-KTCs) in your PanelView 1000e or 1400e terminal. These
cards enable the terminal to communicate with devices on the
ControlNet network and also act as an interface between the terminal
and ControlNet for ControlNet-Direct application file transfers.
The 1784-KTCx card allows the PanelView terminal to communicate
in unscheduled mode. The 1784-KTCs card allows the PanelView
terminal to communicate in scheduled and unscheduled modes.
The 1784-KTCx card is installed in PanelView 1000e and 1400e
operator terminals (A-B Catalog Numbers 2711E-K10C7,
2711E-T10C7, 2711E-K14C7, and 2711E-T14C7).
The 1784-KTCs card is installed in PanelView 1000e and 1400e
operator terminals (A-B Catalog Numbers 2711E-K10C15,
2711E-T10C15, 2711E-K14C15, and 2711E-T14C15).
For information about installing communication cards in the
PanelView terminal see the PanelView ISA Card Adapter Installation
Data Sheet, A-B publication 2711E-5.6.
Important: The DIP switch settings on both the KTCx and KTCs
card must be configured to work with PanelView. If the
settings have been changed and you want to use the
card in the PanelView terminal, you must use the DIP
switches on the KTCx or KTCs card to select the
following addresses:
Address Setting
Base Memory D400:0000
Base I/O 220
Figure 1.3 KTCx and KTCs Switch Settings — Base Memory
Address
Base Memory Address D400:0000
up (1)
down (0)
1 2 1 2 3 4