Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 92)

5–8 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
For PanelView touch screen terminals, the following Transfer
Application screen appears.
2. At the development computer, start the file upload or download.
Use PanelBuilder or the Transfer Utility. You must have the
Transfer Application screen displayed on the terminal.
Note: File transfers are initiated and controlled by the PanelView e
Transfer Utility 32. To cancel a file transfer at the terminal, switch
the terminal to Run mode or cycle power.
Once the upload or download has been initiated, a screen appears
that includes a progress meter. A message indicates when the upload
or download is complete.
If you are downloading to a data partition on a PCMCIA card or the
onboard application memory, and that data partition is full, you can
request the destination be formatted from the PanelBuilder computer.
You cannot stop a format operation. The Exit button is disabled.
"