Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 28)

1–15 Introducing the PanelView Terminals
Publication 2711E-6.17 – November 1998
PLC-3 and PLC-3/10 Processors
One or more terminals can be connected directly to a PLC-3 or
PLC-3/10 remote I/O Scanner along with other I/O racks.
If you are using a 1775-S4A Remote Scanner/Distribution panel, you
must use Series B or higher.
PLC-2 Family Processors via 1771-SN or 1772-SD2
The PLC-2 family includes the PLC-2/05, 2/15, 2/20, and 2/30. One
or more terminals can be connected to these processors with other
I/O racks by the 1771-SN I/O Subscanner Module.
If you are using a 1772-SD2 Scanner/Distribution panel, you must
use Revision 3 or later.
SLC-5/02, 5/03, or 5/04 via 1747-SN Series A or B
One or more terminals can be connected to the 1747-SN I/O
Subscanner Modules (SLC-RIO connection) for the SLC processors.
Each module provides an additional remote I/O link for the host
programmable controller. The rack range of the 1747-SN Series A or
B is 0 to 3.
Important: The 1747-SN Series A supports only discrete data
whereas Series B also provides block transfer support.
Series B also supports Pass-Through communication
capability when used with the 5/04.
1771-SN I/O Subscanner Module
One or more 1771-SN I/O Subscanner Modules can be installed in
any standard Allen-Bradley 1771 I/O rack. Each module provides an
additional Remote I/O link for the host programmable controller.
One or more terminals can be connected to any of the previously
mentioned processors along with other I/O racks via a 1771-SN I/O
Subscanner Module. Refer to the 1771-SN Sub I/O Scanner Module
Data Sheet for details.
6008-SI IBM PC I/O Scanner
This module can be installed in an IBM PC or compatible computer
to provide the computer with an Allen-Bradley 1771 Remote I/O
Link. You can then connect Allen-Bradley Remote I/O racks and
devices such as the PanelView 1000e/1200e/1400e terminal to this
computer.