Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 193)

Installing the PanelView Serial Firmware Upgrade Utility D–4
Publication 2711E-6.17 – November 1998
The Serial Firmware Upgrade Utility Version 5 (SFU32) software is
provided on two disks. Before installing the software, make a backup
copy of the disks. Store the original disks in a safe place, and install
the SFU32 from the copy.
The software installation program creates a directory on your hard
drive for the SFU32 and copies all necessary files to it. By default,
the drive and directory is C:\AB\PB1400E\SFU32. You can change
this default.
To install SFU32:
1. Start Windows NT or Windows 95. If you’re already in Windows,
close all open Windows applications.
2. Insert the floppy disk in the drive.
3. Choose Run from the Start button, and select setup.exe from the
floppy disk drive; or select setup.exe from Windows Explorer.
4. Close all applications, and then choose Next. The Serial
Firmware Upgrade Utility Installation Program runs
automatically.
5. Enter the required information.
6. Choose the drive and directory in which the SFU32 will be
installed. By default, this is C:\AB\PB1400E\SFU32. To change
the destination drive or directory, type the new drive and/or
directory in the Program Files box. Choose Next.
7. Choose the program folder (program group) in which you want to
install the SFU32’s icons, which includes a Readme file icon, the
Upgrade Utility icon, and an Uninstall icon. By default, the icons
are installed in the PanelBuilder 1400e program folder. Choose
Next.
8. Follow the setup instructions as they appear on your screen.
To complete the setup, enter any required information and insert
the second disk when prompted.
Do not cancel the installation while it is in progress. If you want
to undo the installation, let the installation finish, then use the
Uninstall Serial Firmware Upgrade Utility to remove all the
installed files and to update the registration.
9. When the installation is complete, remove the disk from the
drive.
Installing SFU32 from
Floppy Disks on Windows
NT or Windows 95