Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 41)

2–10 Installing PanelView 1000e Terminals
Publication 2711E-6.17 – November 1998
3. Tighten the mounting clip screws to a torque of 10 inch-pounds.
Do not over-tighten.
!
ATTENTION: Tighten mounting clips to a torque of
10 inch-pounds to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley
assumes no responsibility for water or chemical
damage to the terminal or other equipment within the
enclosure because of improper installation.
4. Remove the protective installation label covering the top vents of
the terminal.
!
ATTENTION: Remove the protective installation
label covering the top vents to prevent overheating and
damage to the terminal.
Mounting a Touch Screen Terminal in a 19-inch Rack
To mount the PanelView 1000e Clip-Mount Touch Screen terminals
in a standard 19-inch EIA rack, you need a Rack Mount Kit (A-B
Catalog Number 2711-NR6T). This kit consists of a rack adapter and
mounting hardware.
Mounting a Keypad Terminal in a 19-inch Rack
To mount the PanelView 1000e Clip-Mount Keypad terminals in a
standard 19-inch EIA rack, you need a Rack Mount Kit (A-B
Catalog Number 2711-NR6K). This kit consists of a rack adapter and
mounting hardware.