Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 195)

Installing the PanelView Serial Firmware Upgrade Utility D–6
Publication 2711E-6.17 – November 1998
6. Choose the program folder (program group) in which you want to
install the Serial Firmware Upgrade Utility’s icons, which
includes a Readme file icon, the Utility file icon, and an Uninstall
icon. By default, the icons are installed in the PanelBuilder 1400e
program folder. Choose Next.
7. Follow the setup instructions as they appear on your screen.
To complete the setup, enter any required information and insert
the second disk when prompted.
Do not cancel the installation while it is in progress. If you want
to cancel the installation, let the installation finish, then use the
Uninstall Serial Firmware Upgrade Utility to remove all the
installed files.
8. When the installation is complete, remove the disk from the
drive.
For information on how to start and exit from the Serial Firmware
Upgrade Utility Version 3 (SFU), see the PanelView 1000e, 1200e,
and 1400e Operator Terminals User Manual (A-B Publication
Number 2711E-821).
The Serial Firmware Upgrade Utility supports additional
communication drivers besides the core drivers (Remote I/O, DH+,
ControlNet KTCs, and ControlNet KTCx). If an additional driver is
required, a disk that contains an install and uninstall program is
supplied in the kit for that network driver.
To install an additional driver:
1. Close the Serial Firmware Upgrade Utility before you install the
driver.
2. Insert the floppy disk in the drive.
3. On Windows NT or Windows 95, click the Start button and then
choose Run.
On Windows 3.x, choose Run from the File menu of Program
Manager or File Manager.
4. In the Run dialog box, type:
a:setup or b:setup
5. Follow the installation instructions as they appear on your screen.
When the registration dialog box appears, enter the registration
information that is provided in the kit for the network driver.
Installing Additional
Communication Drivers