Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 284)

5–2 Module Specifications
Publication 1771-6.5.88 – July 1997
The following table lists process control options.
Phase: Type of Profile: Mode:
Injection phase: 10-step profile with
selectable transition velocity vs. position
or
velocity vs. position pressure limited
or
injection pressure vs. position
or
injection pressure vs. time open/closed with ERC
open/closed with ERC
open/closed with ERC
open/closed with ERC
Selectable Transition dependent on:
S Time
S Ram (screw) pressure
S Cavity pressure
S
or Ram (screw) position
N/A N/A
Pack phase: 5-step profile ram (screw) pressure vs. time
or
cavity pressure vs. time open/closed with ERC
open/closed with ERC
Hold phase: 5-step profile ram (screw) pressure vs. time
or
cavity pressure vs. time open/closed with ERC
open/closed with ERC
Plastication phase: 10-step profile backpressure vs. position
or
backpressure vs. time
or
screw RPM vs. position
or
screw RPM vs. time open/closed with ERC
open/closed with ERC
open/closed with ERC
open/closed with ERC
Clamp close phase: three 3-step profiles
(for a total of 9 steps) velocity vs. position
or
pressure vs. position open/closed with ERC
open/closed with ERC
Clamp low pressure close with re-try: 2-step profile pressure vs. position open/closed with ERC
Clamp open phase: three 3-step profiles
(for a total of 9 steps) velocity vs. position
or
pressure vs. position open/closed with ERC
open/closed with ERC
Clamp open slow phase: 2-step profile velocity vs. position
or
pressure vs. position open/closed with ERC
open/closed with ERC
Ejector adv. phase: 3-step profile (with tip strokes) velocity vs. position
or
pressure vs. position open/closed with ERC
open/closed with ERC
Ejector ret. phase: 3-step profile velocity vs. position
or
pressure vs. position open/closed with ERC
open/closed with ERC
Alarms Process
Programming N/A
Control Options P, I, PI, PD, PID, and FF
Expert Response Compensation
Open/Closed Loop N/A
Process Control Options