Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 132)

2–66 Command Word/Bit Descriptions
Publication 1771-6.5.88 – July 1997
Notes: 1. For [ ] engineering units, see page 3.
2. When using the Inject/Clamp/Eject mode, all pressure readings are system pressure at input 2, except where noted.
Word Description
LPC09 Output #1 Set-output Value during Profile [19]
LPC10 Output #2 Set-output Value during Profile [19]
LPC11 Output #3 Set-output Value during Profile [19]
LPC12 Output #4 Set-output Value during Profile [19]
LPC13 Output #5 Set-output Value during Profile [19]
LPC14 Output #6 Set-output Value during Profile [19]
LPC15 Output #7 Set-output Value during Profile [19]
LPC16 Output #8 Set-output Value during Profile [19]
Output Ramp Rates
The module uses the following ramp rates when moving its outputs
from setpoint to setpoint during the Clamp Low Pressure Close
Profile. The module interprets a ramp rate entry of zero as a step
function ramp (ramp disable).
Word Description
LPC17 Output #1 Acceleration Ramp Rate during Profile [20]
LPC18 Output #2 Acceleration Ramp Rate during Profile [20]
LPC19 Output #3 Acceleration Ramp Rate during Profile [20]
LPC20 Output #4 Acceleration Ramp Rate during Profile [20]
LPC21 Output #5 Acceleration Ramp Rate during Profile [20]
LPC22 Output #6 Acceleration Ramp Rate during Profile [20]
LPC23 Output #7 Acceleration Ramp Rate during Profile [20]
LPC24 Output #8 Acceleration Ramp Rate during Profile [20]
LPC25 Output #1 Deceleration Ramp Rate during Profile [20]
LPC26 Output #2 Deceleration Ramp Rate during Profile [20]
LPC27 Output #3 Deceleration Ramp Rate during Profile [20]
LPC28 Output #4 Deceleration Ramp Rate during Profile [20]
LPC29 Output #5 Deceleration Ramp Rate during Profile [20]
LPC30 Output #6 Deceleration Ramp Rate during Profile [20]
LPC31 Output #7 Deceleration Ramp Rate during Profile [20]
LPC32 Output #8 Deceleration Ramp Rate during Profile [20]
End of Profile Set-output Values
When the module completes the Clamp Low Pressure Close Profile, it:
•
sets its outputs to the following values
•
sets status bit SYS22-B03
•
uses ramp rates LPC17 - 32 when changing outputs to these values
Use these values to apply tonnage to the mold before starting the
Injection Profile, or for setting cores if applied before starting the
Injection Profile.