MTS FlexTest Models 200 - Manual (Page 71)

Model 494.42 Single-Station System Board
MTS FlexTest® Models 40/60/100/200 Controller Hardware FlexTest Controller Configurations 71
Digital Output
Relays
Voltage
Current
Output logic
Aux. Voltage
Connector J55 (D9S)
30 V AC/DC maximum
1 A maximum
Output 1: One normally open (NO) contact
Open = Output is OFF
Output 2: One normally open (NO) contact and one
normally closed (NC) contact
NO Contact: Open = Output is OFF
NC Contact: Closed = Output is OFF
Output 3: One normally open (NO) contact
Open = Output is OFF
24 V DC, 0.75 A
UPS Alarm Inputs Connector J56 (D9S)
UPS ACFAIL Alarm Input (switch contact):
Open=UPS ACFAIL active (logic 1)
Closed= UPS ACFAIL not active (logic 0)
UPS Low Battery Alarm Input (switch contact):
Open=UPS Low Battery active (logic 1)
Closed= UPS Low Battery not active (logic 0)
D/A Outputs
Resolution
Output Type
Output Voltage
Output Current
Connector "D/A Output" (D9P)
16 bit
Single ended
+/- 10 V full scale
5.0 mA maximum
Note This connector is located on the rear panel
of the Model 494.04 Chassis.
Model 494.42 Specifications (part 4 of 4)
P ARAMETER S PECIFICATION