MTS FlexTest Models 200 - Manual (Page 301)

Aero Multibox Overview
MTS FlexTest® Models 40/60/100/200 Controller Hardware Aero Multibox Systems 301
Multibox Processor Settings
When used in a multibox system, both processors in each box must have Switch
1 Bit 6 set to the off position.
Note If you remove a box from a multibox system and use it as a standalone
controller (without a Model 49x.43 Multibox board), you must set Switch
1 Bit 6 on both processor boards to the on position.
Typically, when a box is removed from a multibox system, the Model
49x.43 Multibox board remains in the box and Switch 1 Bit 6 on both
processor boards are left in the off position.
7100 Processors 7100 processors do not have multibox switch settings.
• When used in a multibox system, the processor IP address is determined by
the chassis address setting on the Model 49x.43 Multibox board.
• When used in a single-box configuration, the processor IP address defaults
to 148.150.203.191.
Multibox Systems:
Set Switch 1, Bit 6
to the OFF position
Single-box Systems:
If the single-box
system does not include
a Model 49x.43 board,
set Switch 1, Bit 6
to the ON position
If the single-box system
includes a
Model 49x.43 board,
you can leave
Switch 1, Bit 6 in the
OFF position.
Processor Board