MTS FlexTest Models 200 - Manual (Page 177)

Model 494.45 8-Input A/D Converter Card
MTS FlexTest® Models 40/60/100/200 Controller Hardware Mezzanine Cards 177
Model 494.45 8-Input A/D Card Pin Assignments
Analog input signals are typically routed to the A/D card through a Model
494.75 8-Input BNC transition board. Signals are routed to the A/D card
through RJ-50 connectors located on the front of the I/O carrier board that
contains the A/D card.
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors.
The use of other RJ connector types (less than 10 pins or unshielded
with a black boot) with the I/O carrier board can cause component
damage.
Only use cables equipped with 10-pin, braided shielded, RJ-50 connectors
(with gray boot) with the I/O carrier board.
CAUTION
Analog Inputs 1-4
Pin 1 Not used
Pin 2 A/D IN[1]+
Pin 3 A/D IN[1] -
Pin 4 A/D IN[2]+
Pin 5 A/D IN[2] -
Pin 6 A/D IN[3]+
Pin 7 A/D IN[3] -
Pin 8 A/D IN[4]+
Pin 9 A/D IN[4] -
Pin 10 Not used
1
2 3
4 5 6
7 8
Analog Inputs 5-8
Pin 1 Not used
Pin 2 A/D IN[5]+
Pin 3 A/D IN[5] -
Pin 4 A/D IN[6]+
Pin 5 A/D IN[6] -
Pin 6 A/D IN[7]+
Pin 7 A/D IN[7] -
Pin 8 A/D IN[8]+
Pin 9 A/D IN[8] -
Pin 10 Not used
RJ-50 Pin Assignments (front view)
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
494.45 8-Input
A/D
Mezzanine Card
1 2 3 4 5 6 7 8 9 10
Card Slot 1
uses RJ-50
connectors
J1A and J1B
Card Slot 2
uses RJ-50
connectors
J2A and J2B
Card Slot 3
uses RJ-50
connectors
J3A and J3B
Card Slot 4
uses RJ-50
connectors
J4A and J4B
Model 494.40 I/O
Carrier Board