MTS FlexTest Models 200 - Manual (Page 31)

Installation
MTS FlexTest® Models 40/60/100/200 Controller Hardware FlexTest Controller Configurations 31
Installation
This section includes a number of installation requirements for Series 494
Controller Hardware.
Controller Installation Procedure
The following procedure provides a basic outline for the installation of FlexTest
controllers.
1. Unpack the controller.
2. Inspect the controller for any damage.
Note Report any damage to the controller to the shipping agent and MTS.
Controller electronic components can be damaged during shipping.
Using a controller with damaged components can result in injury to
personnel or equipment damage.
Do not attempt to use equipment that was damaged during shipping. Report any
damaged components to the shipping agent and MTS.
3. Move the controller chassis to the desired location.
The Model 494.10 and 494.20 Chassis weighs approximately 45 kg (100 lb)
and 60 kg (132 lb) respectively.
Improper lifting techniques can cause strained muscles and back injuries.
When lifting this chassis, take the appropriate precautions to prevent injuries to
yourself.
CAUTION
CAUTION