MTS FlexTest Models 200 - Manual (Page 32)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Installation
FlexTest Controller Configurations 32
The Model 494.06 Chassis has a removable front cover that could loosen
when attempting to lift the chassis.
Lifting the Model 494.06 Chassis without first removing the front cover can
result in injury to personnel or equipment damage.
Remove the front cover on the Model 494.06 Chassis before attempting to lift the
Model 494.06 Chassis.
4. Connect power and cables as required.
If you attempt to change a cable connection while the system is in
operation, an open control loop condition can result.
An open control loop condition can cause a rapid, unexpected system
response which can result in severe personal injury, death, or damage to
equipment.
Do not change any cable connections when the system is capable of motion
(electric drives are enabled, hydraulic pressure is applied, etc.). Ensure that all
cables are connected after you make any changes in the system configuration.
Also, ensure that all cables are properly connected after you make any changes in
the system configuration.
CAUTION
WARNING