MTS FlexTest Models 200 User Manual
Page 266
MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.74 Two-Station HSM Interface Board
Digital I/O and Transition Boards
266
Cable specification
To maintain EMC compliance, J3 Interlock cables must comply with the
following specifications:
Connector–15-contact, type D, male EMI connector.
Backshell–EMI metallized plastic or metal.
Cable–AWG and number of conductors as required. Braided shield with
shield connected to the metallized backshell at the chassis.
Jumper plug required
If connector J3 is not used, you must install a jumper plug to maintain the
integrity of the interlocks. Use jumper plug part number 100-180-351 or
jumper pins: 1 and 4; 2 and 10; 9 and 12.
This manual is related to the following products: