MTS FlexTest Models 200 - Manual (Page 68)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.42 Single-Station System Board
FlexTest Controller Configurations 68
Model 494.42 System Board Specifications
Model 494.42 Specifications (part 1 of 4)
P ARAMETER S PECIFICATION
E-Stop/Run
Output Relay
Contacts
Voltage
Current
Connector J23 (D9S)
30 V DC/AC maximum
1 A maximum
Two (2) Normally Open Estop Relay Contacts:
HPU E-Stop = Open
Set of NO/NC Prog. Run Relay Contacts:
Normally Open Contacts: Prog. Run = Closed
Normally Closed Contacts: Prog. Run = Open
HPU Outputs
(Start/Low/High)
HPU Outputs
(start, low, high)
HPU ON Input
Connector J25 (D15P)
Output Voltage: 24 V DC at 250 mA
Trip Voltage: 0.8–10.0 V DC
Maximum Input Voltage: +26 V DC
HPU Interlock
Inputs (Low Level
and Overtemp)
Trip-point Voltage
Connector J25 (D15P)
0.8–10.0 V DC
Maximum Input Voltage: +26 V DC