MTS FlexTest Models 200 - Manual (Page 165)

Model 494.16 VD/DUC Mezzanine Card
MTS FlexTest® Models 40/60/100/200 Controller Hardware Mezzanine Cards 165
Model 494.16 VD/DUC Card Pin Assignments
Signals are routed to and from the DUC and valve driver through two RJ-50
connectors located on the front of the I/O carrier board.
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors with a gray boot.
The use of other RJ connector types (less than 10 pins or unshielded
with a black boot) with the I/O carrier board can cause component
damage.
Only use transducer cables equipped with 10-pin, braided shield, RJ-50
connectors (with a gray boot) with the I/O carrier board.
CAUTION
1 2 3 4 5 6 7 8
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
RJ-50 Pin Assignments
(front view)
Cable Grounding
1 The cable shield connects to
the metal shielding on the RJ-
50 cable plug.
2 The cable plug shielding
connects to the I/O carrier
board body.
3 The I/O carrier board body
connects to earth ground
through the chassis.
DUC
Pin 1 + IEEE 1451.4 Class 2
Pin 2 +EX
Pin 3 -EX
Pin 4 -FB
Pin 5 +FBR
Pin 6 -FBR
Pin 7 +FB
Pin 8 -EXS
Pin 9 +EXS
Pin 10 - IEEE 1451.4 Class 2
Valve Driver
Pin 1 + IEEE 1451.4 Class 2
Pin 2 +VD CH1
Pin 3 -VD CH1
Pin 4 Spare
Pin 5 Analog Gnd.
Pin 6 Analog Gnd.
Pin 7 Spare
Pin 8 +VD CH2
Pin 9 -VD CH2
Pin 10 - IEEE 1451.4 Class 2
1 2 3 4 5 6 7 8 9 10
Card Slot 1
uses RJ-50 connectors
J1A and J1B
Card Slot 2
uses RJ-50 connectors
J2A and J2B
Card Slot 3
uses RJ-50 connectors
J3A and J3B
Card Slot 4
uses RJ-50 connectors
J4A and J4B