MTS FlexTest Models 200 - Manual (Page 139)

Mezzanine Cards
MTS FlexTest® Models 40/60/100/200 Controller Hardware Mezzanine Cards 139
3. Align the mezzanine card.
A. Place the I/O carrier board flat on an antistatic surface.
If the I/O carrier board is not flat, you will not be able to properly
install the mezzanine cards.
B. Align the mezzanine card connectors with the mating connectors
on the I/O carrier board.
When properly aligned, you should be able to slightly move the
mezzanine card back and forth (A) within the connector.
A
Correct Incorrect
Mezzanine
Card
Connector
I/O Carrier
Connector
Connector Alignment (side view)