MTS FlexTest Models 200 - Manual (Page 270)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.76 8-Output BNC Transition Board
Digital I/O and Transition Boards 270
Model 494.76 8-Output BNC Transition Board
About the Model 494.76 8-Output BNC Transition Board
Analog output signals are typically routed to external devices through a
Model 494.76 8-Output BNC transition board. The transition board connects
to the front-panel I/O carrier board connectors associated with the D/A
converter mezzanine card slot (J3A and J3B).
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors with a gray boot.
The use of other RJ connector types (less than 10 pins or unshielded
with a black boot) with the I/O carrier board can cause component
damage.
Only use transducer cables equipped with 10-pin, braided shield, RJ-50
connectors (with a gray boot) with the I/O carrier board.
CAUTION
First
494.76 ANALOG OUTPUT CH 1 - 8
Last
J11
J12
1 2 3 4 5 6 7 8
Model 494.76 8-Output
BNC Transition Board Model 494.40 I/O Carrier Board
Transition
Card Cage
VME Card Cage
Analog
Outputs
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
Output 7
Output 8
Outputs 1-4
Outputs 5-8
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
494.46 8-Output
D/A Mezzanine Card