MTS FlexTest Models 200 - Manual (Page 299)

Aero Multibox Overview
MTS FlexTest® Models 40/60/100/200 Controller Hardware Aero Multibox Systems 299
Add HPU and HSM Boards to the Master Controller Box
Each multibox system requires an HPU board and a HSM board. These boards
must only be installed in the first box in the chain (Master box).
• Model 493.73 HPU board with E-Stop input
• Model 493.74 (or 494.74) HSM board with Station-Stop input
Important If reconfiguring a system, you must remove any HPU and HSM
boards from the dependent boxes.
Board locations
The HPU/HSM board locations depend on the type of HSM board used. Use the
following table to determine the correct board locations.
HPU/HSM Board Locations
B OARD T YPE M ODEL 494.74 S INGLE -W IDTH HSM B OARD M ODEL 493.74 D OUBLE -W IDTH HSM B OARD
Model 493.73 HPU Board Transition Slot 3 Transition Slot 4
HSM Board HSM 1-2: Transition Slot 2
HSM 3-4: Transition Slot 1
HSM 1-2: Transition Slot 3
HSM 3-4: Transition Slot 1