MTS FlexTest Models 200 - Manual (Page 215)

Model 493.31 16-Channel Low-Current DI/O Breakout Box
MTS FlexTest® Models 40/60/100/200 Controller Hardware Digital I/O and Transition Boards 215
Digital Output Connections for the Model 493.31 Breakout Box
The J4 Out connector provides up to sixteen digital output signals that can
control external devices. These digital-output signals are controlled by
controller software.
Breakout box
connections
Device connections–each output device connects to a terminal plug that is
inserted into one of the 16 output sockets on the digital I/O breakout box.
Power connections–you can connect an external power supply to connector
J21. This supply voltage is distributed to each of the 16 output sockets on
the digital I/O breakout box.
DI/O board connections
A cable from J4 on the Model 493.72 Digital I/O board connects all 16
digital-output signals to connector J20 on the Digital I/O Breakout box.
Each digital output on the Model 493.72 board has an opto-isolator that
controls the power to a device connected to the digital I/O breakout box.
For more information
The connection drawings show pin assignments for output 1. For a complete
list of pin assignments, see
“Digital I/O Connections for the Model 493.31
DI/O Breakout Box” on page 213.
J4
OUT
493.31 DI/O Breakout Box
19
18
1
20
36
37
+ 12 VDC
J20
OUT
19
18
1
20
36
37
493.72 Digital I/O
Transition Board
Opto-
Isolator
Jumper
External
Device
From
Controller