Xerox 4112-4127 Enterprise Printing System-192 User Manual
Page 83
PDL principles and procedures
Using LCDS Print Description Language
1-57
Figure 1-14. Text Editor window
2. In the Text Editor window, code the JDL name, starting at the
left edge of the window workspace.
3. Code the system or JDL level ID commands with their
identifiers.
Recommended:
•
Before beginning your system level commands, code a
comment line stating that the following entries are system
level commands.
•
For each command, at the beginning of the line, enter the
identifier, followed by a colon (:) and the command
keyword. Tab or space over until the cursor is
approximately 20 character spaces from the left edge of
the Text Editor workspace, then enter the first parameter
keyword.
•
For each subsequent parameter of the system level
command, tab or space over about 20 character spaces
to enter the parameter, aligning it under the previous
parameter.
•
Code the VFU (vertical format unit) first.