Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 291)

Specifying print format parameters
Using LCDS Print Description Language 4-51
Options
Default NONE
OUTPUT
CYCLEFORMS
parameter: points
to note
• If multiple CYCLEFORMS are specified in the same
OUTPUT command, a single list consisting of all these
specified forms is created. The forms are listed in the order
the names are encountered. The number of form identifiers is
limited only by the number of forms retained on the disk.
• CYCLEFORMS and FORMS: Both may be used within a
report; however, only the parameter that was specified most
recently is in effect at any given time. If a multicopy report
specifies CYCLEFORMS, a FORMS DJDE that is
encountered in the report overrides the CYCLEFORMS
parameter from that point in every copy.
• For colored forms: If an inkref that is on the ink list is
omitted from the command, commas must be used to
maintain the relative positioning of the remaining ink
references.
If more than two inkrefs are specified, the system ignores the
additional inkrefs.
OUTPUT
CYCLEFORMS
parameter
example
OUTPUT CYCLEFORMS=(form1, form2)
Table 4-48. OUTPUT CYCLEFORMS parameter options and definitions
Option Definition
NONE Specifies that no form will be added to the associated report page of variable
data.
formid Specifies a 1 to 6 character form file name (may be numeric, alpha, or
alphanumeric), which exists on the system disk.
INKS Specifies that the inks that follow will be used for the forms.
inkref Identifies the inks that override the corresponding inks that are specified in the
ink list of the form. If a form does not contain an ink list, the form is printed in
black.