Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 319)

Specifying print format parameters
Using LCDS Print Description Language 4-79
Options
Default NO
OUTPUT SHIFT
parameter: points
to note
• If the origin of a print line is off the page, the printer prints as
much of the line as possible and provides a message, once
per report, indicating that printing is off the page.
• Graphics and logos are not allowed to start off the page. If
they are positioned at a point that is outside the page
boundary, an error message is displayed.
OUTPUT SIZING
Specifies how the system matches the paper sizes in the output
bins and how it responds to paper and bin size mismatches.
When a stock has more than one tray assignment, and these
trays contain different size paper, the system tries to match the
paper sizes in the trays. You can specify one of the following
options based on whether or not the printer will be attended by
an operator during printing.
Syntax OUTPUT SIZING = {SEMIAUTO | STOP | BEST | EXACT}
Table 4-72. OUTPUT SHIFT parameter options and definitions
Option Definition
v
1
value 1.
An integer value in dots for the amount of shift on the simplex page or the odd
(front) side of the duplex page. (Each dot is 1/300 of an inch.)
The range for v
1
is –75 to 75.
v
2
value 2.
A value in dots for the amount of shift on the even (back) side of a duplex page.
The range for v
2
is –75 to 75.
YES Specifies that a shift occurs. A standard size shift occurs if YES is specified
(v
1
=75 and v
2
= –75).
NO Specifies that no shift occurs (v
1
=0 and v
2
=0).