Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 130)

Specifying input parameters
2-22 Using LCDS Print Description Language
Example 2 In this example, consecutive input codes, such as X’5B’ and
X’5C’, need not be specified to accomplish code modification.
CODE SPACECODE
Defines the blank (space) character code for the single-byte
character set.
Syntax ac: CODE SPACECODE = spacecode,
Options
Default X’20’(CODE=ASCII), X’40’(CODE not ASCII)
CODE
SPACECODE
parameter: point
to note
SPACECODE must be specified after the DEFAULT parameter.
If SPACECODE is specified before DEFAULT, the spacecode
value is overwritten by X’20’ or X’40’.
Hexadecimal output option strings (such as X’20’), as well as text
string constants (for example, a), are not translated before being
put into the code assignment table. Therefore, you should keep
ASCII or, more precisely, the encoding of the fonts that will be
used, in mind when you use hexadecimal strings.
DBCODE command
Defines a double-byte character code translation table.
When you require a user defined translation table of double-byte
character codes, you define the double-byte character
translation using the DBCODE command, then reference this
command using the VOLUME DBCODE parameter. As an
alternative, you can use the USER option of the VOLUME
DBCODE parameter to reference the DBCODE command for
which no identifier was provided.
CODE2: CODE DEFAULT=EBCDIC,
ASSIGN=(X'5A',(X'40',X'40',
X’40’));
Table 2-18. CODE SPACECODE parameter options and definitions
Option Definition
spacecode Defines the code for a blank space.