Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 315)

Specifying print format parameters
Using LCDS Print Description Language 4-75
What to do:
In order to run the job in succession, you must code the JSL
with MOD=5 and POS=1 for Job 1 and MOD=5 and POS=5
for Job 2. The system keeps track of the last tab position in
tray 2 at the end of Job 1. Upon starting Job 2, printer purges
Tab 3 and Tab 4 because Job 2 starts with POS=5 and Job 1
used Tab 1 and Tab 2.
• You can improve performance by ordering application
dependent tab stock. Using ordered tab stock that supports
only the number of tabs required for a specific job eliminates
the need for purging unused tabs.
OUTPUT PAPERSIZE
Specifies the size of paper that will be used for printing the job.
Syntax OUTPUT PAPERSIZE = {A3 | A4 | B4 | B5 | USLEGAL |
USLETTER | (x, y)}
Options
Default System default size that was specified at installation
OUTPUT
PAPERSIZE
parameter: points
to note
• When centimeters (CM) are used to specify paper size, the
maximum allowable value is 32,767 cm.
• Paper size cannot be changed by a DJDE on a page basis.
However, paper sizes can be changed on a report basis.
Table 4-68. OUTPUT PAPERSIZE parameter options and definitions
Option Definition
A3 16.54 by 11.69 inches / 297 by 420 mm
A4 8.27 by 11.69 inches / 287 by 270 mm
B4 10.12 by 14.33 inches / 257 by 364 mm
B5 7.17 by 10.12 inches / 178 by 254 mm (with the 7 by 10 inch enablement kit)
USLEGAL 8.5 by 14 inches / 216 by 356 mm
USLETTER 8.5 by 11 inches / 216 by 279 mm
(x, y) A user defined paper size; that is, a size that is not one of the standard sizes.
The x and y variables define the width and length of the nonstandard stock;
e.g., 7,10 for 7 by 10 inches.