Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 423)

Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-69
Options
SIDE DJDE: points to note
• The SIDE DJDE takes effect at a logical page boundary.
• The SIDE DJDE options are the same as for the RPAGE
command, SIDE parameter.
• The SIDE DJDE should be used instead of, not in
conjunction with, the RPAGE command. It overrides both
the RPAGE SIDE and ROFFSET parameters, if they apply to
the next logical page. Thus, it triggers repositioning of only a
single logical page and does not otherwise override the
RPAGE SIDE or ROFFSET parameters on subsequent
pages.
Table 5-58. SIDE DJDE options and definitions
Option Definition
sideopt side option.
In duplex (with no BFORM): The four sideopt options produce the
following results:
NUFRONT The specified logical page is positioned as the first logical page on a new
sheet.
BACK The specified logical page is positioned as the first logical page of the next
available back.
NUBACK The specified logical page is positioned as the first logical page on the
back of a new sheet.
NEXT The specified logical page is positioned as the first logical page on the
next available side: the back of the current sheet or the front of the next
sheet.
The logical page is moved unless it is already properly positioned as the
first logical page on the specified side.
In simplex, or in duplex with BFORM: The sideopt parameter is forced to NUFRONT, and the
specified page is positioned as the first logical page.
If the logical page is already properly positioned, a blank sheet is not created.
offsetopt Specifies whether sheets containing repositioned logical pages will be
offset in the stacker.
The available offsetopt parameters are:
• OFFSET Causes the sheet on which the repositioned logical page
occurs to be offset.
• NOFFSET No offset occurs.
The default offset option is NOFFSET.