Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 406)

Using Dynamic Job Descriptor Entries (DJDEs)
5-52 Using LCDS Print Description Language
LOGO DJDE: points to note
• Any logos specified in a selected JDE (the JDE that was
specified in the JDE DJDE) replace those from the original
JDE. If none are specified in the selected JDE, logos from the
original JDE are canceled.
• If the logo that is specified in the Initial JDE is not found, the
job aborts and an error message is displayed. If a logo that is
specified after the start of the job is not found, the system
response is determined by the specifications in the
ABNORMAL ERROR parameter.
• The HERE keyword must be included whenever the VADJ or
HADJ options are coded. Otherwise, a syntax error occurs.
• If inks are used:
– If one inkref in the list is omitted, commas must be used
as place holders to maintain the relative positioning of the
remaining ink references.
– If more than two ink references are specified, the
additional ink references are ignored.
LPI DJDE
Specifies the values for the vertical spacing between subsequent
lines.
Type Record oriented
Syntax LPI = {(linespacing [units], DEFAULT) | (linespacing [units],
lineno, (...))}
Options
Table 5-42. LPI DJDE options and definitions
Option Definition
linespacing lines per inch
Specifies the line spacing value. May be measured in:
units Unit of measure for the amount of vertical line space. The options are:
•
LPI (lines per inch)
• DOTS
• XDOTS (600 dpi)
The default unit is LPI.