Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 317)

Specifying print format parameters
Using LCDS Print Description Language 4-77
Options
Default YES
OUTPUT PURGE
parameter: point
to note
You can use the SAVE DJDE to override the purging of specific
files.
OUTPUT SF1FUNCTION
Specifies to the third party finisher whether or not it should
perform the user-defined SF1 operation on the current report.
This parameter provides control over third party finishing devices
that conform to the DFA standard. You use it to invoke Finishing
Function SF1 through the DFA channel C6. The user must
specify what function SF1 will have. Refer to your finishing
equipment vendor documentation for information on what
function should be specified for your finisher.
Syntax OUTPUT SF1FUNCTION = {NO | YES}
Options
Default NO
Table 4-69. OUTPUT PURGE parameter options and definitions
Option Definition
NO Specifies that graphic disk files should not be deleted.
YES Specifies that all .IMG graphics files that were created or replaced by
document interleaved graphic processing for this report should be deleted
at the end of the report printing.
Table 4-70. OUTPUT SF1FUNCTION parameter options and definitions
Option Definition
YES Instructs the finisher to initiate the user-defined SF1 finishing function on the
current sheet.
NO Specifies that Finishing Function SF1 will not be implemented on the current
sheet.