Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 127)

Specifying input parameters
Using LCDS Print Description Language 2-19
Figure 2-1. Sample BLOCK command diagram
CODE command
Defines a character code translation table.
When you require a user defined character code translation
table, you define the character translation using this command,
then reference the CODE command using the VOLUME CODE
parameter. As an alternative, you can use the USER option of
the VOLUME CODE parameter to reference the CODE
command for which no identifier was provided.
ac identifier A command identifier of the type ac is optional for the first
CODE command within a JDE. Thereafter, each additional
CODE command must include the identifier. The ac identifier
consists of 1 to 6 alphanumeric characters (A through Z and 0
through 9). One of the characters must be alphabetic.
CODE command parameters
The following table summarizes the CODE command
parameters.
Table 2-15. Summary of CODE command parameters
Parameter Specifies Online Offline DJDE
CODE ASSIGN Defines user code assignments. Y Y N
CODE DEFAULT Specifies a base code from which character
code assignment exceptions can be made. Y Y N
CODE SPACECODE Specifies the blank code for single-byte
characters Y Y N