Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 253)

Specifying print format parameters
Using LCDS Print Description Language 4-13
Refer to “Importing LCDS resources” in the “PDL principles and
procedures” chapter for the procedure for copying resources to
the /opt/XRXnps/resources/lcds/ folder from elsewhere within
the Unix file system.
NOTE: When you modify a CME source file, you must recompile
it with the xjdc command. It is not necessary to recompile the
associated JDLs.
When a CME is referenced in a JDL that does not contain that
CME, the system searches the “lcds” folder for the CME file
(which has the file type extension .CME). The CME file is then
loaded into memory for use in processing the report.
The MODIFY DJDE can also be used to dynamically associate a
catalogued CME file with report processing.
NOTE: CMEs must be catalogued as separate disk files if they
are referenced by a MODIFY DJDE.
CME command parameters
The following table summarizes the CME command parameters.
The following sections describe the syntax of the CME command
parameters and explain their options.
Table 4-14. Summary of the CME command parameters
Parameter Specifies Online Offline DJDE
CME CONSTANT Specifies the copy modification character string
that will be printed. Y Y N
CME FONT Selects the fonts for printing input or CME data. Y Y N
CME INK Specifies the ink for printing the variable data
that is affected by the CME Y Y N
CME LINE Specifies the range of lines on which copy
modification occurs. Y Y N
CME POSITION Specifies the character position at which copy
modification begins on a page. Y Y N