Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 270)

Specifying print format parameters
4-30 Using LCDS Print Description Language
Options
Default offset: 0
termination: DEFAULT
LINE INKINDEX
Specifies a field within a data record that contains a number that
represents the ink index in the current ILIST.
Syntax LINE INKINDEX = {offset | (offset [, initval [, bitopt]]) | NONE}
Options
Default NONE
Table 4-31. LINE GDATA parameter options and definitions
Option Definition
offset The starting point of the graphic data.
termination The terminating byte of the record. The options are:
•
DEFAULT
–
If online, a single terminating byte exists.
– If offline, no terminating byte exists.
• n: The number of terminating bytes that exist
Table 4-32. LINE INKINDEX parameter options and definitions
Option Definition
offset Indicates the byte offset in the data record where the ink index number is
located.
initval initial value.
Specifies an index value that is associated with the first ink in the ink list. Must
be ONE or ZERO.
•
“ZERO” specifies that the first ink on the ink list is considered “ink 0.”
• “ONE” indicates that the first ink on the ink list is considered “ink 1.”
The default initval is ONE.
bitopt bit option
Specifies the number of bits that should be used in calculating the ink index.
The range is 1 through 7.
The default bitopt value is 4.
NONE Specifies that there is no ink index.