Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 399)

Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-45
INKINDEX DJDE
Specifies a field within a data record that contains a number that
represents the ink index in the current ILIST.
Type Page oriented
hpos horizontal position.
Specifies the horizontal position of the left edge of the graphic, as a rightward
offset, relative to 0,0 on the current physical page.
Specified as a decimal number with up to three digits to the right of the decimal
point and may be followed by a space and the units indicator.
NOTE: The default value for the hpos parameter is 0.
units Specifies the unit of measure for the vertical and horizontal positions of the
image on the page. Available units are:
•
DOTS
• CM (centimeters)
• IN (inches)
• UN (user defined unit)
• XDOTS (DOTS at 600 spi)
If UN is specified, the user defined positioning unit must be previously defined
by the OUTPUT UNITS command in the current JDE or JDL.
The default positioning unit is IN.
H HOLD
Specifies that the same graphic is to be held and imaged without further
callouts, at the same position and with the same scale factor on all subsequent
pages until changed by a DJDE CANCEL or ALTER.
T PAGE INTERLEAVED (Type of graphic)
Specifies that the referenced graphic is page interleaved and follows the
current page data in the input stream.
n / d numerator / denominator.
Specifies the reference scale factor. Each parameter, n and d, must be an
integer in the range of 1 to 8, thereby allowing a reference scale factor in the
range of 1/8 to 8.
The reference scale factor is multiplied by the scale factor specified at the time
the graphic was digitized and the product is rounded to the nearest integer in
the range 1 to 8. That integer becomes the effective scale factor with which the
graphic is imaged.
INKS Specifies that the ink references that follow will override the inks that were
defined in the image file.
inkref ink reference
Specifies the inks that override the corresponding inks specified in the ink list of
the image file.
Table 5-34. IMAGE DJDE options and definitions (Continued)
Option Definition