Xerox 4112-4127 Enterprise Printing System-192 - Manual (Page 424)

Using Dynamic Job Descriptor Entries (DJDEs)
5-70 Using LCDS Print Description Language
STOCKS DJDE
Identifies the stock set and its associated stock(s) to be used in a
report. This stockset file (STOCKSETNAME.STK) must already
have been created by a compiled JSL and must currently reside
in the “lcds” resource folder on the system disk.
Type Page oriented
Syntax STOCKS = stocksetname
Options
STOCKS DJDE: point to note
Whenever a new stockset is chosen, that is, at start of report or
through a JDE or JDL switch via DJDE, the system verifies each
stock to determine that the stock exists and can be made active.
This verification provides an automatic method of changing
stocks in the printer as required by the data stream.
TMODE DJDE
Specifies a maximum paper width in order to improve throughput
efficiency when using mixed paper sizes. Refer to the “OUTPUT
TMODE” parameter section in the “Specifying print format
parameters” chapter for an explanation of pitch mode.
NOTE: This feature is not supported by the Nuvera MX series
printers.
Type Page oriented
Syntax TMODE = (width [, widthunit])
Table 5-59. STOCKS DJDE options and
definitions
Option Definition
stocksetname Name of the STOCKSET used in a report.